GEARTREE 2744 Triangle Extension Arm

The Falcam GearTree 2744 Heavy-Duty Triangle Extension Arm is designed for use with the GearTree Floor-to-Ceiling Stand (sold separately). Made from high-strength aluminum alloy, as well as its sturdy triangular structure, allows the triangular extension arm to bear loads of up to 30kg, making it suitable for heavier lights and other accessories.  

Load-Capacity 

Made from aluminium alloy, and its triangular structure, GearTree 2744 extension arm can bear loads of up to 30kg, enabling you to mount virtually any studio light or accessory with the greatest of confidence.

Connectors

Falcam GearTree 2744 triangle arm connects to the floor-to-ceiling stand with two mounting ring clamps (sold separately). Being mounted at two separate points gives the triangle extension arm a huge amount of strength. The arm also features 2x 5/8-inch stud receivers, enabling you to mount any of the other accesses in the GearTree studio grip system.

The triangle extension arm is ideal for mounting heavier lights or other accessories to your GearTree floor-to-ceiling studio grip system. An essential accessory for owners of the GearTree studio grip system.

Instructions

Install the two clamps onto the stand, with about 210cm apart.
Insert the stud on the upper end of the triangle extension arm into one clamp’s mounting point
Adjust the lower stud and insert it into the other clamp’s mounting point.
Adjust the triangle arm and tighten the locking crew
Reserve the installation steps when removing the arm.

Note:

The triangle extension arm is designed to be used along with two clamps (with mounting point). It can be only installed on the floor-to-ceiling stand, otherwise, it may fall. Remove all loads from the arm before installing, removing or adjusting the arm.

NOTE: Not for use with desk studio products. 

Contents:

1x Triangle Extension Arm
2x Locking Screw
2x Jack Bolt
1x H3 Hey Key H3
4x Magic Strap